KINETIC DYNAMIC SUSPENSION SYSTEM PROBLEM SYMPTOMS TABLE

Tip:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table.
Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Table 1. Kinetic Dynamic Suspension System
Symptom	Suspected Area	Link
Kinetic dynamic suspension system DTC cannot be output (When using intelligent tester)	CAN communication system	Click here
	Harness or connector (power source of stabilizer control ECU)	Click here
	Stabilizer control ECU	Click here
Kinetic dynamic suspension system DTC cannot be output (When not using intelligent tester)	CAN communication system	Click here
	Harness or connector (power source of stabilizer control ECU)	Click here
	Stabilizer control ECU	Click here
	Combination meter	Click here
KDSS indicator light does not come on	CAN communication system	Click here
KDSS indicator light does not come on	Combination meter	Click here
Vehicle is tilted	Stabilizer control solenoid valve	Click here
	Fluid leakage	Click here
	Bleed air (check for clogs in hydraulic circuit and lack or excess of fluid)	Click here
Roll is not controlled when driving	Brake control system	Click here
	Stabilizer control solenoid valve	Click here
	Fluid leakage	Click here
	Bleed air (check for clogs in hydraulic circuit and lack or excess of fluid)	Click here
	Accumulator pressure sensor	Click here