COMBINATION METER REMOVAL

PROCEDURE

  1. DISABLE AUTOAWAY/RETURN FUNCTION

    1. Disable the Autoaway/Return function by changing the customize parameter (Click here).

      Note:

      Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tip:

      Performing the above operation causes the Autoaway/Return function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.

    3. Turn the engine switch off.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

    Note:

    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. REMOVE NO. 2 SWITCH HOLE BASE

    Click here

  4. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION

    Click here

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    1. E204082C01

      *1

      Protective Tape

      Place protective tape as shown in the illustration.

    2. Detach the 4 claws.

    3. E204083

      Detach the 2 clips.

    4. Detach the 4 claws.

    5. Detach the guide and remove the instrument cluster finish panel sub-assembly.

  6. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  7. REMOVE COMBINATION METER ASSEMBLY

    1. E204084

      Remove the 2 screws.

    2. Detach the 2 clips.

    3. Disconnect the connector and remove the combination meter assembly.