SFI SYSTEM(w/ EGR System), Diagnostic DTC:P060A
| DTC Code | DTC Name |
|---|---|
| P060A | Internal Control Module Monitoring Processor Performance |
DESCRIPTION
The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, a DTC is stored.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
Warning Indicate |
Memory |
|---|---|---|---|---|---|
P060A |
Internal Control Module Monitoring Processor Performance |
A CPU reset is performed after one of the following conditions is met (1 trip detection logic):
|
ECM |
Comes on |
DTC stored |
MONITOR STRATEGY
Required sensors/Components (Main) |
ECM |
Frequency of operation |
Once per driving cycle |
CONFIRMATION DRIVING PATTERN
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the engine switch on (IG) and wait for 16 seconds or more.
PROCEDURE
CHECK FOR DTC
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Clear DTCs.
Powertrain > Engine and ECT > Clear DTCs
Turn the tester off.
Turn the engine switch off.
Disconnect the intelligent tester.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the tester on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Check for DTCs.
Powertrain > Engine and ECT > Trouble Codes
OK
P060A is not output.
Result
Result
OK
NG