REAR SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (SKID CONTROL SENSOR)

    1. Install the rear axle hub and bearing LH (Click here).

  2. INSTALL SKID CONTROL SENSOR WIRE

    1. Pass the skid control sensor wire under the flexible hose and connect the skid control sensor wire connector to the skid control sensor.

      Note:

      • To prevent interference with other parts, do not twist the painted line areas of the sensor wire when installing it.

      • Do not twist the sensor wire when installing the clamp.

    2. Attach the 2 grommets.

    3. Install the sensor clamp with the nut.

      8.5 N*m

      87 kgf*cm

      75 in.*lbf

      Note:

      Do not twist the sensor wire when installing the clamp.

    4. Install the sensor clamp with the nut.

      8.0 N*m

      82 kgf*cm

      71 in.*lbf

      Note:

      Do not twist the sensor wire when installing the clamp.

    5. C194708E07

      Insert the connector and grommet into the inside of the vehicle through the hole in the wheel house.

      Table 1. Text in Illustration

      *1

      Grommet

      *2

      Band Clamp

      *3

      Connector

      *a

      Inside of Vehicle
      Note:

      Make sure the band clamp remains on the outside of the vehicle.

    6. C194709E09

      Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.

      Table 2. Text in Illustration

      *a

      Outside of Vehicle

      *b

      30°
      Note:

      • When pulling out the grommet, do not grip the sensor wire.

      • Fix the grommet in place within the range shown in the illustration.

    7. Connect the skid control sensor wire connector to the vehicle side connector on the rear floor.

  3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

    1. w/o Rear No. 2 Seat:

      Install the deck trim side panel assembly LH (Click hereClick here).

    2. w/ Rear No. 2 Seat:

      Install the deck trim side panel assembly LH (Click hereClick here).

  4. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click hereClick here

  5. INSTALL REAR DISC

    Click here

  6. CONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH

    Click here

  7. INSTALL REAR WHEEL

    103 N*m

    1050 kgf*cm

    76 ft.*lbf

  8. CHECK SPEED SENSOR SIGNAL

    1. Check the speed sensor signal (Click here).