PANORAMIC VIEW MONITOR SYSTEM, Diagnostic DTC:C2A5D

DTC Code DTC Name
C2A5D BSM Buzzer Malfunction

DESCRIPTION

This DTC is stored when the rear television camera assembly receives an RCTA buzzer circuit malfunction signal from the blind spot monitor sensor RH.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C2A5D BSM Buzzer Malfunction The RCTA buzzer circuit is abnormal. Blind spot monitor system Rear television camera assembly

CAUTION / NOTICE / HINT

Note


  • When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here

PROCEDURE


  1. READ VALUE USING GTS (BLIND SPOT MONITOR SENSOR LH STATUS)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Blind Spot Monitor Slave / Data List.

    5. Read the Data List according to the display on the GTS.


      Body Electrical > Blind Spot Monitor Slave > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Buzzer Connection Status of the buzzer connection Valid or Invalid

      Valid: Buzzer connection is valid

      Invalid: Buzzer connection is invalid

      		 -
      Slave Side RCTA Function Switches the RCTA function on and off OFF or ON

      OFF: RCTA function off

      ON: RCTA function on

      		 -

      Body Electrical > Blind Spot Monitor Slave > Data List
      Tester Display
      Buzzer Connection
      Slave Side RCTA Function
      Result
      Result Proceed to
      "Valid" and "ON" is displayed for all items. A
      "Invalid" or "OFF" is displayed. B

    B

    GO TO BLIND SPOT MONITOR SYSTEM Click here

    A

  2. CHECK FOR DTC


    1. Clear the DTCs.


      Chassis > Parking Assist Camera > Clear DTCs

    2. Recheck for DTCs and check that no DTCs are output.


      Chassis > Parking Assist Camera > Trouble Codes
      Result
      Result Proceed to
      DTC C2A5D is output A
      DTC C2A5D is not output B

    B

    REPLACE REAR TELEVISION CAMERA ASSEMBLY Click here

    A

  3. CHECK FOR DTC (BLIND SPOT MONITOR SYSTEM (C1ABE))


    1. Check for DTCs.


      Body Electrical > Blind Spot Monitor Slave > Trouble Codes
      Result
      Result Proceed to
      DTC C1ABE is output A
      DTC C1ABE is not output B

    A

    GO TO DIAGNOSTIC TROUBLE CODE CHART (C1ABE) Click here

    B

    GO TO BLIND SPOT MONITOR SYSTEM (PROBLEM SYMPTOMS TABLE) Click here