STEERING WHEEL INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral with sensor cable sub-assembly with the battery connected and the engine switch on (IG).

  • Do not rotate the spiral with sensor cable sub-assembly when the following conditions are met: 1) The steering wheel is removed, 2) the battery is connected,and 3) the engine switch is on (IG).

  • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY


    1. w/o Steering Wheel Vibration:

      Click here

    2. w/ Steering Wheel Vibration:

      Click here

  2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

    Click here

  3. INSTALL STEERING SHAKE DAMPER


    1. Install the 2 screws and steering shake damper to the steering wheel assembly.

  4. INSTALL STEERING PAD SWITCH ASSEMBLY

    Click here

  5. INSTALL CRUISE CONTROL MAIN SWITCH

    Click here

  6. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  7. ADJUST SPIRAL CABLE

    Click here

  8. INSTALL STEERING WHEEL ASSEMBLY


    1. Align the matchmarks on the steering wheel assembly and steering main shaft.

    2. Install the steering wheel assembly set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

    3. Connect the connector.

    4. Connect each connector to the spiral cable with sensor sub-assembly.

  9. INSTALL STEERING PAD

    Click here