AIRBAG CUT-OFF SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the front passenger side of RHD and LHD vehicles.

  • The procedures listed below are for the front passenger side of LHD vehicles.

PROCEDURE

  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick hereClick hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  3. REMOVE AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

    1. B339280C01

      *1

      Protective Tape

      Put protective tape around the airbag cut off switch cylinder sub-assembly.

    2. Using a screwdriver, detach the 2 claws.

      Tip:

      Tape the screwdriver tip before use.

    3. Disconnect the connector to remove the airbag cut off switch cylinder sub-assembly.