TIRE PRESSURE WARNING RECEIVER INSTALLATION

PROCEDURE

1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

   
   

   1. Connect the 2 connector.

   2. 

      	Nut
      	Connector

      Install the tire pressure warning ECU and receiver with the nut.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Note

      
      

      • Do not reuse a tire pressure warning ECU and receiver which has been subjected to an impact or dropped.

      • 

        If the removed nut is the same shape as that shown in the illustration, replace it the supplied replacement part.

2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH

   Click here

3. INSTALL SIDE TRIM BOX

   Click here

4. INSTALL REAR FLOOR FINISH PLATE

   Click here

5. INSTALL ROPE HOOK ASSEMBLY

   Click here

6. INSTALL REAR LUGGAGE COMPARTMENT TRIM COVER

   Click here

7. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

   Click here

8. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER

   Click here

9. INSTALL INNER LOWER LUGGAGE COMPARTMENT TRIM COVER

   Click here

10. INSTALL TOOL BOX

    Click here

11. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

12. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH

    Click here

13. INSTALL LUGGAGE COMPARTMENT TRIM BOX (w/o Air Suspension)

    Click here

14. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

16. LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

17. REGISTER TRANSMITTER ID

    Click here

18. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

19. PERFORM INITIALIZATION

    Click here