BACK DOOR COURTESY SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • When installing a new back door lock assembly, if there is any tape stuck to it, remove the tape.

  • When installing a new back door lock assembly, if there are any strings attached to it, cut the strings off.

  • Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.

PROCEDURE

  1. INSTALL BACK DOOR LOCK ASSEMBLY (BACK DOOR COURTESY SWITCH)

    1. w/ Power Back Door:

      1. B421521

        Apply MP grease to the sliding parts of the back door lock assembly (back door courtesy switch).

      2. Install the back door lock assembly (back door courtesy switch) with the 4 bolts.

        7.0 N*m

        71 kgf*cm

        62 in.*lbf

      3. Connect the connectors.

    2. w/o Power Back Door:

      1. B421522

        Apply MP grease to the sliding parts of the back door lock assembly (back door courtesy switch).

      2. Install the back door lock assembly (back door courtesy switch) with the 3 bolts.

        7.0 N*m

        71 kgf*cm

        62 in.*lbf

      3. Connect the connector.

  2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY

    Click here

  3. INSTALL BACK DOOR SIDE GARNISH LH

    Click here

  4. INSTALL BACK DOOR SIDE GARNISH RH

    Click here

  5. INSTALL CENTER BACK DOOR GARNISH

    Click here