KNOCK SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of throttle body with motor assembly

  • Cleaning the deposits from the throttle body with motor assembly

  • Replacement of knock control sensor

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE INTAKE MANIFOLD

    Click here

  2. REMOVE KNOCK CONTROL SENSOR


    1. B007XG3

      Disconnect the knock control sensor connector.

    2. Remove the bolt and knock control sensor from the cylinder block sub-assembly.

      Note

      If the knock control sensor has been struck or dropped, replace it.