TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE

  1. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    1. Remove the front exhaust pipe assembly (Click here).

  2. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here)

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  4. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  5. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  6. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  7. REMOVE BATTERY

  8. REMOVE BATTERY TRAY

  9. REMOVE BATTERY CARRIER

    Click here

  10. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  11. REMOVE AIR CLEANER CASE

    Click here

  12. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    (Click here)

  13. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

    C207447

    1. Remove the 3 nuts and front No. 1 floor heat insulator.

  14. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

    1. C207443E04

      Disconnect the control shift cable from the shift lever assembly.

      Table 1. Text in Illustration

      *1

      Select Cable

      *2

      Shift Cable

    2. Pinch the areas indicated by the arrows and disconnect the control select cable.

    3. C207444

      Detach the 2 claws and disconnect the control cable assembly.

    4. C201606

      Remove the 2 clips and disconnect the 2 cables from the transaxle.

    5. C201605

      Remove the 2 clips and disconnect the 2 cables from the control cable bracket.

    6. C207454

      Remove the bolt and detach the bracket of the control cable assembly.

    7. C207449

      Remove the 2 nuts and detach the grommet of the control cable assembly.