CANISTER INSPECTION


  1. INSPECT CHARCOAL CANISTER ASSEMBLY


    1. Check the appearance.


      1. Visually check the charcoal canister assembly for cracks or damage.

        If necessary, replace the charcoal canister assembly.

    2. Check the charcoal canister filter.


      1. B007R3EE02
        Text in Illustration
        *1 Charcoal Canister Filter
        *a Claw

        Detach the 2 claws and remove the charcoal canister filter.

      2. B007T0ZE02
        Text in Illustration
        *1 Charcoal Canister Filter

        Visually check that the charcoal canister filter is not excessively damaged or dirty.

        If necessary, replace the charcoal canister assembly.

    3. Check the charcoal canister operation.


      1. B007P10E02
        Text in Illustration
        *a Port A
        *b Port B
        *c Port C
        B007USN Air

        Blow air (4.7 kPa (0.05 kgf/cm2, 0.7 psi)) into port A, then check that the air flows from ports B and C.

        If the ventilation is not as specified, replace the charcoal canister assembly.

    4. Clean the filter in canister.


      1. B007QXWE02
        Text in Illustration
        *a Port A
        *b Port B
        *c Port C
        B007USN Air

        Clean the filter by blowing (19.6 kpa (0.2 kgf/cm2, 2.8 psi)) compressed air into port B while holding port A closed.

        Note


        • Do not attempt to wash the charcoal canister assembly.

        • No activated carbon should come out.

    5. Install the charcoal canister filter.