REAR QUARTER WINDOW GLASS REMOVAL


  1. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH


    1. B007QB0

      Remove the bolt and disconnect the front seat outer belt assembly LH.

    2. B007Q86E02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 2 claws and open the cover.

      Tech Tips

      Tape the screwdriver tip before use.

    3. B007RIY

      Remove the bolt and disconnect the front seat outer belt assembly LH.

  2. REMOVE BACK DOOR SCUFF PLATE


    1. B007U93E01

      Detach the 7 clips and 4 claws and remove the back door scuff plate.

  3. REMOVE BACK DOOR WEATHERSTRIP

  4. REMOVE QUARTER TRIM PANEL ASSEMBLY REAR LH


    1. B007T7W

      Detach the 35 clips and remove the quarter trim panel assembly rear LH.

  5. REMOVE QUARTER PILLAR GARNISH LH


    1. B007QJOE02

      Detach the 6 clips and remove the quarter pillar garnish LH.

  6. REMOVE ROOF SIDE GARNISH INNER UPPER LH


    1. B007REG

      Using a screwdriver, detach the 6 clips and remove the roof side garnish inner upper LH.

      Tech Tips

      Tape the screwdriver tip before use.

  7. REMOVE EMERGENCY HAMMER CAUTION PLATE (w/ Emergency Hammer Caution Plate)

    Tech Tips


    • If a emergency hammer caution plate is damaged, replace it with a new one.

    • Only for the RH side.


    1. Remove the emergency hammer caution plate.

  8. REMOVE REAR QUARTER WINDOW GLASS


    1. Apply protective tape to the outer surface of the vehicle body to prevent scratches.

      B007QLZE01
      Text in Illustration
      *A w/o Window Seal Set Plate *B w/ Window Seal Set Plate

    2. From the interior, insert piano wires between the vehicle body and rear quarter window glass as shown in the illustration.

    3. Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.

      Note

      When separating the rear quarter window glass from the vehicle, be careful not to damage the vehicles paint or interior/exterior ornaments.

    4. Cut through the adhesive by pulling the piano wire around the rear quarter window glass.

    5. Using a suction cup, remove the rear quarter window glass.

      Note

      Leave as much adhesive on the vehicle body as possible when removing the rear quarter window glass.

  9. REMOVE NO. 1 REAR SIDE WINDOW ADHESIVE DAM LH


    1. Using a scraper, remove the No. 1 rear side window adhesive dam LH.

      Note


      • Be careful not to damage the No. 1 rear side window adhesive dam LH.

      • Be sure to replace the No. 1 rear side window adhesive dam LH with a new one.

  10. REMOVE REAR SIDE WINDOW SEAL SET PLATE LH (w/ Window Seal Set Plate)


    1. B007USS

      Using a scraper, remove the rear side window seal set plate LH.

      Note


      • Be careful not to damage the rear side window assembly LH.

      • Be sure to replace the rear side window seal set plate LH with a new one.