СТАРТЕР (для моделей мощностью 2,7 кВт) ПОВТОРНАЯ СБОРКА


  1. INSTALL STARTER ARMATURE ASSEMBLY


    1. B007W1Z

      Install the starter armature to the starter yoke.

  2. INSTALL STARTER BRUSH HOLDER ASSEMBLY


    1. Place the brush holder assembly on the starter yoke assembly.

    2. B007SXS

      Using a screwdriver, hold the brush spring back.

    3. Connect the brush into the brush holder.

    4. Connect the 4 brushes.

      Note

      Check that the positive (+) lead wires are not grounded.

    5. B007TUZ

      Install the commutator end frame with the 2 screws.

      Torque:
      3.6 N*m  { 37 kgf*cm, 32 in.*lbf }

  3. INSTALL MAGNET STARTER SWITCH ASSEMBLY


    1. Apply grease to the steel ball, and return spring.

    2. Install the steel ball into the magnet starter switch hole.

    3. Insert the return spring into the magnet starter switch hole.

    4. B007R2NE04

      Place the following parts in position on the starter housing.

      (1) Starter clutch sub-assembly
      (2) Starter idler pinion
      (3) Retainer
      (4) Clutch roller
      (5) Plate washer
    5. B007RZ5

      Install the starter housing to the magnet magnet switch assembly with the 3 screws.

      Torque:
      9.3 N*m  { 95 kgf*cm, 82 in.*lbf }

  4. INSTALL STARTER YOKE ASSEMBLY


    1. Install the felt washer to the starter armature.

    2. B007SC8E01

      Install the starter yoke to the starter switch.

      Tech Tips

      Align the claw of the starter yoke with the groove of the starter switch.

    3. B007UQM

      Tighten the 2 through bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    4. Connect the terminal C wire with the nut.

      Torque:
      24 N*m  { 245 kgf*cm, 18 ft.*lbf }