ULTRASONIC SENSOR(for Front) INSTALLATION

PROCEDURE

  1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

    Tip:

    • Align the slit of the No. 1 ultrasonic sensor retainer with the protrusion of the front bumper cover and install the No. 1 ultrasonic sensor retainer.

    • Pay attention to the protrusions of the front bumper cover as the orientation of the retainer changes depending on the installation position.

    • Use the same procedure for all No. 1 ultrasonic sensor retainers.

    E270035E01
    Table 1. Text in Illustration

    *a

    Rear View of Front Bumper

    -

    -
    1. E212142E02

      Attach the 4 claws to install the No. 1 ultrasonic sensor retainer to the front bumper cover.

      Note:

      Do not damage the bumper cover with the protrusion when installing the retainer.

      Table 2. Text in Illustration

      *a

      Slit

      *b

      Protrusion

  2. INSTALL NO. 1 ULTRASONIC SENSOR

    Tip:

    Use the same procedure for all No. 1 ultrasonic sensors.

    1. E201175

      Attach the 2 claws to install the No. 1 ultrasonic sensor.

  3. INSTALL NO. 4 ENGINE ROOM WIRE

    1. Attach the 6 clamps to install the No. 4 engine room wire.

      E270034

    2. Connect the 4 connectors.

  4. INSTALL FRONT BUMPER COVER

    Click here

  5. INSTALL RADIATOR GRILLE PROTECTOR

    Click here

  6. INSTALL RADIATOR SUPPORT OPENING COVER

    Click here

  7. ADJUST FOG LIGHT ASSEMBLY

    (Click here)