REAR UPPER ARM INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL REAR UPPER CONTROL ARM ASSEMBLY


    1. Temporarily install the rear upper control arm assembly to the rear suspension member sub-assembly with the bolt, nut and washer.

      Note

      Because the bolt has its own stopper, do not turn the bolt. Tighten the nut with the bolt secured.

    2. B004EGWN01

      Set the rear upper control arm assembly in the tightening position as shown in the illustration.

      Reference Length (A)
      1.0 mm (0.0394 in.)

    3. Fully tighten the nut.

      Torque:
      150 N*m  { 1530 kgf*cm, 111 ft.*lbf }

      Note

      Because the bolt has its own stopper, do not turn the bolt. Tighten the nut with the bolt secured.

  2. INSTALL REAR NO. 1 UPPER CONTROL ARM ASSEMBLY


    1. Temporarily install the rear No. 1 upper control arm assembly to the rear suspension member sub-assembly with the bolt, nut and washer.

      Note

      Because the bolt has its own stopper, do not turn the bolt. Tighten the nut with the bolt secured.

    2. B004FAUN01

      Set the rear No. 1 upper control arm assembly in the tightening position as shown in the illustration.

      Reference Length (A)
      9.0 mm (0.354 in.)

    3. Fully tighten the nut.

      Torque:
      150 N*m  { 1530 kgf*cm, 111 ft.*lbf }

      Note

      Because the bolt has its own stopper, do not turn the bolt. Tighten the nut with the bolt secured.

  3. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here