REAR DIFFERENTIAL CARRIER ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL REAR DIFFERENTIAL SUPPORT


    1. Install the rear differential support to the rear differential carrier assembly with 4 new bolts.

      Torque:
      72 N*m  { 734 kgf*cm, 53 ft.*lbf }

  2. INSTALL REAR NO. 1 DIFFERENTIAL SUPPORT


    1. Install the rear No. 1 differential support to the rear differential carrier assembly with 2 new bolts.

      Torque:
      55 N*m  { 561 kgf*cm, 41 ft.*lbf }

  3. INSTALL REAR NO. 2 DIFFERENTIAL SUPPORT


    1. Install the rear No. 2 differential support to the rear differential carrier assembly with 2 new bolts.

      Torque:
      55 N*m  { 561 kgf*cm, 41 ft.*lbf }

  4. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY


    1. Support the rear differential carrier assembly with a transmission jack or equivalent.

    2. Slowly raise the transmission jack, and install 3 new bolts.

      B008M4EN02
      Torque:
      for bolt A
      86 N*m  { 877 kgf*cm, 63 ft.*lbf }
      for bolt B
      106 N*m  { 1080 kgf*cm, 78 ft.*lbf }

    3. Install the breather tube.

    4. Install the wire harness clamp bracket with the bolt.

      Torque:
      19.6 N*m  { 200 kgf*cm, 14 ft.*lbf }

    5. Connect the connector.

    6. Connect the 2 harness clamps.

  5. INSTALL MAIN MUFFLER HEAT INSULATOR


    1. Install the main muffler heat insulator to the vehicle body with the 4 nuts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  6. INSTALL REAR DRIVE SHAFT ASSEMBLY LH


  7. INSTALL REAR DRIVE SHAFT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  8. INSTALL REAR STABILIZER BAR

    Click here

  9. INSTALL NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY

    Click here

  10. INSTALL NO. 2 FUEL TANK PROTECTOR

    Click here

  11. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

    Click here

  12. ADD DIFFERENTIAL OIL

    Click here

  13. INSTALL REAR WHEEL

    Click here