SPIRAL CABLE REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  4. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  5. INSPECT SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY


    1. Check that the front wheels are facing straight ahead.

    2. B008HTAC01
      *a Check Window
      *b Top of Flat Cable U-turn

      Check that the spiral cable sub-assembly with sensor is center position.

      OK
      The connector is at the top.
      The top of the flat cable U-turn can be checked from the check window.

      Note

      If the result is not as specified, it is possible that the spiral cable sub-assembly with sensor is broken. Replace the spiral cable sub-assembly with sensor with a new one.

  6. REMOVE LOWER STEERING COLUMN COVER

    for Manual Tilt and Manual Telescopic Steering Column:

    Click here

    for Power Tilt and Power Telescopic Steering Column:

    Click here

  7. REMOVE UPPER STEERING COLUMN COVER

    for Manual Tilt and Manual Telescopic Steering Column:

    Click here

    for Power Tilt and Power Telescopic Steering Column:

    Click here

  8. REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

    Note


    • Do not replace the spiral with sensor cable sub-assembly with the battery connected and the engine switch on (IG).

    • Do not rotate the spiral with sensor cable sub-assembly with the battery connected and the engine switch on (IG).

    • When rotating the spiral with sensor cable sub-assembly to check the operation of the sub-assembly (checking for abnormal noise, checking the Data List, etc.), make sure to perform the inspection with the steering wheel assembly installed.


    1. B008HPGC02
      *a Slider

      Slide the slider to release the lock, and then disconnect the airbag connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    2. Disconnect each connector.

    3. B008HNV

      Detach the 3 claws and remove the spiral with sensor cable sub-assembly.