ECM REMOVAL

PROCEDURE

1. PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

   Click hereClick here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click hereClick hereClick here

3. REMOVE NO. 2 CYLINDER HEAD COVER

   Click here

4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

   Click here

5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

   1. 

      Detach the wire harness clamp from the air cleaner case sub-assembly.

   2. Remove the 3 bolts and air cleaner case sub-assembly.

6. REMOVE ECM

   1. Disconnect the 2 ECM connectors.

      Note:

      After disconnecting a connector, make sure that dirt, water and other foreign matter does not contact the connector.

      1. 

         *a	Push
         *b	Lock

         Raise the 2 levers while pushing the locks on the 2 levers and disconnect the 2 ECM connectors.

   2. 

      Remove the 3 bolts and ECM.

7. REMOVE NO. 1 ECM BRACKET

   1. 

      Remove the 2 screws and No. 1 ECM bracket.

8. REMOVE NO. 2 ECM BRACKET

   1. 

      Remove the 2 screws and No. 2 ECM bracket.