REAR DOOR BELT MOULDING REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE DECK BOARD ASSEMBLY

    Click here

  3. REMOVE NO. 1 DECK BOARD

    Click here

  4. REMOVE NO. 2 DECK BOARD

    Click here

  5. REMOVE REAR DECK FLOOR BOX

    Click here

  6. REMOVE DECK FLOOR BOX RH

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  9. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  10. REMOVE REAR DOOR ARMREST COVER

    Click here

  11. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  12. REMOVE REAR DOOR TRIM BRACKET

    Click here

  13. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  14. REMOVE REAR DOOR GLASS RUN

    Click here

  15. REMOVE REAR DOOR WINDOW GUIDE SUB-ASSEMBLY

    Click here

  16. REMOVE REAR DOOR REAR GUIDE SEAL

    Click here

  17. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  18. REMOVE REAR DOOR BELT MOULDING ASSEMBLY


    1. A0059RQE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the rear door belt moulding assembly.

    2. A005AH5E03
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, disengage the 8 claws and remove the rear door belt moulding assembly.

      Tech Tips

      Tape the screwdriver tip before use.