DIFFERENTIAL MOUNT CUSHION INSTALLATION

PROCEDURE

  1. INSTALL REAR NO. 1 DIFFERENTIAL MOUNT CUSHION

    1. Using SST, install a new rear No. 1 differential mount cushion.

      09316-12010

      09570-24011

      C279649C02

      *1

      Rear Suspension Member Sub-assembly

      -

      -

      *a

      0° +/- 3°

      *b

      5.0 to 6.0 mm (0.197 to 0.236 in.)
      V100136

      Front of Vehicle

      -

      -
      Note:

      • Make sure that the differential mount cushion is aligned within 3° from the center.

      • Be sure to use the correct combination of SST.

      • Before using SST, apply grease to SST bolt.

      • Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.

      • Make sure that SST contacts the entire circumference of the rear No. 1 differential mount cushion.

      • Do not tilt the bolts of SST.

  2. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click hereClick here

  3. INSTALL REAR DIFFERENTIAL CARRIER SUB-ASSEMBLY

    Click hereClick hereClick here

  4. INSTALL REAR DIFFERENTIAL DYNAMIC DAMPER LH

    1. Install the rear differential dynamic damper LH (front side) with the 2 bolts to the rear No. 1 differential support.

      39 N*m

      398 kgf*cm

      29 ft.*lbf

  5. INSTALL REAR DIFFERENTIAL DYNAMIC DAMPER RH

    1. Install the rear differential dynamic damper RH (front side) with the 2 bolts to the rear No. 2 differential support.

      39 N*m

      398 kgf*cm

      29 ft.*lbf