STEERING GEAR INSPECTION

PROCEDURE

  1. INSPECT TIE ROD END SUB-ASSEMBLY LH

    1. C132329

      Secure the tie rod end between aluminum plates in a vise.

      Note:

      Do not overtighten the vise.

    2. Install the nut to the stud bolt.

    3. Flip the ball joint back and forth 5 times.

    4. Set a torque wrench on the nut, turn the ball joint continuously at a rate of 3 to 5 seconds per turn, and check the turning torque on the 5th turn.

      Standard turning torque

      0.98 to 3.92 N*m (10.0 to 39.9 kgf*cm, 8.67 to 34.7 in.*lbf)

      If the turning torque is not within the specified range, replace the tie rod end sub-assembly LH with a new one.

  2. INSPECT TIE ROD END SUB-ASSEMBLY RH

    Tip:

    Use the same procedures described for the LH side.

  3. INSPECT TOTAL PRELOAD

    1. C363628E01

      Using SST and a torque wrench, check the total preload.

      09616-00011

      Standard total preload

      0.6 to 1.2 N*m (6.1 to 11.7 kgf*cm, 5.3 to 10.2 in.*lbf)

      Note:

      Perform the inspection with the steering rack centered.

      If the total preload is not within the specified range, replace the steering gear assembly with a new one.