LIGHTING SYSTEM, Diagnostic DTC:B242E

DTC Code DTC Name
B242E Open in IG Circuit

DESCRIPTION

This DTC is stored when a malfunction occurs in the headlight ECU sub-assembly LH IG power source circuit. The headlight ECU sub-assembly LH stores DTC B242E.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B242E Open in IG Circuit Open in the headlight ECU sub-assembly LH IG power source circuit

  • Headlight ECU sub-assembly LH

  • Harness or connector

 -

WIRING DIAGRAM

A001XMLE04
*a from IG1-NO. 1 Relay
*b ECU-IG1 NO. 3
*c Instrument Panel Junction Block Assembly
*d Headlight ECU Sub-assembly LH

CAUTION / NOTICE / HINT

Note


  • Inspect the fuses for circuits related to this system before performing the following procedure.

  • If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.

    Click here

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT

  2. CHECK FOR DTC


    1. Turn the ignition switch to ON.

    2. Check for DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Trouble Codes
      OK
      DTC B242E is not output.
      Result
      Proceed to
      OK
      NG

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

  3. CHECK HARNESS AND CONNECTOR (HEADLIGHT ECU SUB-ASSEMBLY LH - POWER SOURCE AND BODY GROUND)


    1. Disconnect the A16 headlight ECU sub-assembly LH connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      A16-4 (IG) - Body ground Ignition switch off Below 1 V
      A16-4 (IG) - Body ground Ignition switch ON 11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A16-12 (GND) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR