FRONT SEAT ASSEMBLY(for Power Seat) INSTALLATION

PROCEDURE


  1. PRECAUTION

    CAUTION:


    • Be sure to read Precaution thoroughly before servicing Click here.

    • Wear protective gloves. Sharp areas on the parts may injure your hands.

  2. INSTALL FRONT SEAT ASSEMBLY


    1. Place the front seat assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. Connect each connector under the front seat assembly.

    3. Connect the cable to the negative (-) auxiliary battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    4. Temporarily install the front seat assembly with the 4 bolts.

    5. Operate the slide and vertical power seat switch knob and move the front seat assembly to the rearmost position.

    6. A005E2JE05

      Tighten the 2 bolts on the front side of the front seat assembly.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Note

      Tighten the bolts in the order shown in the illustration.

    7. Operate the slide and vertical power seat switch knob and move the front seat assembly to the foremost position.

    8. A005BA1E05

      Tighten the 2 bolts on the rear side of the front seat assembly.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Note

      Tighten the bolts in the order shown in the illustration.

  3. INSTALL REAR INNER SEAT TRACK BRACKET COVER


    1. Engage the guide.

    2. Engage the claw to install the rear inner seat track bracket cover.

  4. INSTALL REAR OUTER SEAT TRACK BRACKET COVER


    1. Engage the 2 claws to install the rear outer seat track bracket cover.

  5. INSTALL FRONT INNER SEAT TRACK BRACKET COVER


    1. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

    2. Engage the 2 claws to install the front inner seat track bracket cover.

  6. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER


    1. Engage the 2 claws to install the front outer seat track bracket cover.

  7. INSTALL FRONT SEAT HEADREST ASSEMBLY

  8. INSTALL DECK FLOOR BOX RH

    Click here

  9. INSTALL REAR DECK FLOOR BOX

    Click here

  10. INSTALL NO. 1 DECK BOARD

    Click here

  11. INSTALL NO. 2 DECK BOARD

    Click here

  12. INSTALL DECK BOARD ASSEMBLY

    Click here

  13. INSPECT FRONT SEAT ASSEMBLY


    1. Check the power seat operation Click here

    2. Check the seat heater operation.


      1. Turn the power switch on.

      2. Turn the seat heater switch on.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.

  14. INSPECT SRS WARNING LIGHT

    Click here