POWER WINDOW REGULATOR MOTOR REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

    Click hereClick here

  4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

    Click hereClick here

  5. REMOVE FRONT DOOR TRIM COVER

    Click hereClick here

  6. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (w/o Mirror Heater)

    Click hereClick here

  7. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (w/ Mirror Heater)

    Click hereClick here

  8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click hereClick here

  9. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP ASSEMBLY

    Click hereClick here

  10. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click hereClick here

  11. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click hereClick here

  12. REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY

    1. B372096

      Disconnect the connector.

    2. Remove the 6 bolts and front door window regulator assembly.