LUGGAGE COMPARTMENT DOOR ADJUSTMENT

CAUTION / NOTICE / HINT

*a	Centering Bolt
*b	Standard Bolt

Tip:

• Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

• Specified torque for standard bolts is shown in the standard bolt chart.

  Click here

PROCEDURE

1. INSPECT LUGGAGE COMPARTMENT DOOR

   1. Check that the clearance measurements of areas ''a'' through ''d'' are within each standard range.

      

      Table 1. Standard Clearance

      Area	Measurement	Area	Measurement
      a	8.0 mm (0.315 in.)	b	2.0 to 5.0 mm (0.0787 to 0.197 in.)
      c	-1.2 to 1.2 mm (-0.00472 to 0.0472 in.)	d	3.85 to 7.85 mm (0.152 to 0.309 in.)

2. REMOVE LUGGAGE COMPARTMENT DOOR COVER

   Click hereClick here

3. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER LH

   Click hereClick here

4. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER RH

   Click hereClick here

5. REMOVE SPARE WHEEL COVER

   Click here

6. REMOVE REAR FLOOR FINISH PLATE

   Click here

7. ADJUST LUGGAGE COMPARTMENT DOOR

   1. 

      Loosen the door side hinge bolts to adjust the door horizontally and vertically.

      7.5 N*m

      76 kgf*cm

      66 in.*lbf

   2. 

      Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.

   3. Using a brass bar and a hammer, hit the striker to adjust its position.

   4. Using a T40 "TORX" socket wrench, tighten the striker mounting screws after adjustment.

      23 N*m

      235 kgf*cm

      17 ft.*lbf

8. INSTALL REAR FLOOR FINISH PLATE

   Click here

9. INSTALL SPARE WHEEL COVER

   Click here

10. INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER RH

    Click hereClick here

11. INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER LH

    Click hereClick here

12. INSTALL LUGGAGE COMPARTMENT DOOR COVER

    Click hereClick here