REAR DIFFERENTIAL CARRIER ASSEMBLY INSTALLATION

PROCEDURE

INSTALL REAR DIFFERENTIAL SUPPORT
1. Install the rear differential support to the differential carrier sub-assembly with a new 4 bolts.
  
  98 N*m
  
  999 kgf*cm
  
  72 ft.*lbf
INSTALL REAR NO. 1 AND NO. 2 DIFFERENTIAL SUPPORT
1. Install the rear No. 1 and No. 2 differential supports with a new 4 bolts to the differential carrier sub-assembly.
  
  55 N*m
  
  561 kgf*cm
  
  41 ft.*lbf
INSTALL REAR DRIVE SHAFT ASSEMBLY LH

Click here
INSTALL REAR DRIVE SHAFT ASSEMBLY RH

Tip:
Use the same procedure described for the LH side.
INSTALL DIFFERENTIAL CARRIER SUB-ASSEMBLY
1. Support the rear differential carrier with a transmission jack or equivalent.
2. Slowly raise the transmission jack, and install the 3 bolts.
  
  for bolt A
  
  88.8 N*m
  
  906 kgf*cm
  
  65 ft.*lbf
  
  for bolt B
  
  106 N*m
  
  1080 kgf*cm
  
  78 ft.*lbf
  Note:
  - Tighten the bolts, not the nuts.
  - Install a new bolt (labeled B).
3. Install the breather tube.
4. Install the wire harness clamp bracket with the bolt.
  
  20 N*m
  
  204 kgf*cm
  
  15 ft.*lbf
5. Connect the connector.
6. Connect the 2 harness clamps.
INSTALL REAR SUSPENSION MEMBER BRACE LH
1. Install the member brace with the 2 bolts to the suspension member.
  
  35 N*m
  
  357 kgf*cm
  
  26 ft.*lbf
INSTALL REAR SUSPENSION MEMBER BRACE RH

Tip:
Use the same procedure described for the LH side.
INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

Click here
INSTALL EXHAUST PIPE ASSEMBLY
1. for 1AD-FTV:
  Click here Click here
2. for 2AD-FHV:
  Click here Click here
3. for 2AD-FTV:
  Click here Click here
4. for 2AR-FE:
  Click here
5. for 3ZR-FAE:
  Click here Click here
6. for 3ZR-FE:
  Click here
INSTALL FUEL TANK ASSEMBLY
1. for 1AD-FTV:
  Click here Click here
2. for 2AD-FHV:
  Click here Click here
3. for 2AD-FTV:
  Click here Click here
4. for 2AR-FE:
  Click here
5. for 3ZR-FAE:
  Click here Click here
6. for 3ZR-FE:
  Click here
ADD DIFFERENTIAL OIL

Click here