STARTER(w/ Stop And Start System) INSTALLATION

PROCEDURE

1. INSTALL STARTER ASSEMBLY

   
   

   1. Install the starter assembly with the 2 bolts.

      Torque:

      46 N*m  { 469 kgf*cm, 34 ft.*lbf }

   2. Connect the starter connector.

   3. Connect the starter wire with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   4. Close the terminal cap.

2. INSTALL BATTERY BRACKET REINFORCEMENT

   
   

   1. Install the battery bracket reinforcement with the 2 bolts.

      Torque:

      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

3. INSTALL BATTERY CARRIER ASSEMBLY

   
   

   1. Install the battery carrier assembly with the 4 bolts.

      Torque:

      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

   2. Attach the 6 clamps and connect the wire harness.

4. INSTALL BATTERY TRAY

5. INSTALL BATTERY

6. INSTALL BATTERY INSULATOR

7. INSTALL BATTERY CLAMP SUB-ASSEMBLY

   
   

   1. Attach the hook of the battery clamp sub-assembly to the battery carrier assembly.

   2. Partially tighten the nut and temporarily install the bolt.

   3. Adjust the battery clamp sub-assembly position.

   4. Tighten the bolt and nut.

      Torque:

      for Bolt

      16.5 N*m  { 168 kgf*cm, 12 ft.*lbf }

      for Nut

      4.9 N*m  { 50 kgf*cm, 43 in.*lbf }

8. CONNECT CABLE TO POSITIVE BATTERY TERMINAL

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

10. PERFORM INITIALIZATION

    Click here