POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

3. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

   Click here

4. REMOVE REAR DOOR TRIM MOULDING LH

   Click here

5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

   Click here

6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

7. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH

   Click here

8. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

   Click here

9. REMOVE REAR DOOR SERVICE HOLE COVER LH

   Click here

10. REMOVE REAR DOOR GLASS RUN LH

    Click here

11. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

12. REMOVE REAR DOOR QUARTER WINDOW GLASS LH

    Click here

13. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

14. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY LH

    1. 

       Disconnect the connector.

       Table 1. Text in Illustration

       *1	Temporary Bolt

    2. Loosen the temporary bolt.

       Note:

       Do not remove the temporary bolt. If the temporary bolt is removed, the rear door window regulator may fall and cause damage.

    3. Remove the 3 bolts.

    4. Remove the rear door window regulator assembly.

    5. Remove the temporary bolt from the rear door window regulator.