STOP LIGHT SWITCH INSTALLATION

PROCEDURE

1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

   1. Engage the 2 claws to install the stop light switch mounting adjuster.

2. INSTALL STOP LIGHT SWITCH ASSEMBLY

   1. 

      Insert the stop light switch assembly until the threaded sleeve hits the pedal.

      Note:

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

   2. 

      Turn the stop light switch assembly a quarter turn clockwise to install the stop light switch assembly.

      1.5 N*m

      15 kgf*cm

      13 in.*lbf

      or less

      Note:

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

   3. Connect the connector.

   4. Check the protrusion of the plunger.

      Table 1. Protrusion of the Plunger

      Area	Measurement
      a	0.5 to 2.6 mm (0.0197 to 0.102 in.)

      If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary.

      for LHD:Click hereClick here

      for RHD:Click here

      Note:

      Do not depress or support the brake pedal.

3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Instrument Panel Under Cover)

   for Sedan:Click hereClick here

   for Hatchback, Wagon:Click hereClick here