| DTC Code | DTC Name |
|---|---|
| P023A00 | Charge Air Cooler Coolant Pump Control Circuit/Open |
| P023A71 | Charge Air Cooler Coolant Pump Control Actuator Stuck |
DESCRIPTION
Refer to DTC P023A12.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P023A00 | Charge Air Cooler Coolant Pump Control Circuit/Open | The speed of the electric water pump assembly is higher than the target speed by a certain amount or more (2 trip detection logic). |
|
Does not come on | DTC stored | SAE Code: P023A |
| P023A71 | Charge Air Cooler Coolant Pump Control Actuator Stuck | The speed of the electric water pump assembly is lower than the target speed by a certain amount or more (2 trip detection logic). | Electric water pump assembly | Does not come on | DTC stored | SAE Code: P023A |
MONITOR DESCRIPTION
The ECM monitors the speed of the electric water pump assembly. If the actual speed exceeds the target speed by a certain amount or more, the ECM determines overspeed operation has occurred. If the actual speed is less than the target speed by a certain amount or more, the ECM determines that the motor is stuck and stores a DTC.
CAUTION / NOTICE / HINT
Tech Tips
P023A00 may be stored if there is insufficient coolant in the turbocharger and intercooler cooling system. If there is sufficient coolant in the system and P023A00 is output when the vehicle is brought to the workshop, check if the customer has added coolant in the past.
If the electric water pump assembly voltage is extremely high or low, control may be temporarily stopped and P023A71. When the voltage returns to normal, control will resume and it will not be necessary to replace the electric water pump assembly.
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
PROCEDURE
CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P023A00 OR P023A71)
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | ||||||
|---|---|---|---|---|---|---|
|
Tech Tips
If any DTCs other than P023A00 or P023A71 are output, troubleshoot those DTCs first.
| B |
|
GO TO DTC CHART Click here |
| A |
|
PERFORM ACTIVE TEST USING GTS (CONTROL THE INTERCOOLER WATER PUMP)
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Note
Be sure to perform the inspection with the battery voltage at 11 V or more.
Tech Tips
If the battery voltage is low, the electric water pump assembly may stop operating.
Enter the following menus: Powertrain / Engine / Active Test / Control the Intercooler Water Pump / Data List / Intercooler Water Pump Speed.
| Active Test Display |
|---|
| Control the Intercooler Water Pump |
| Data List Display |
|---|
| Intercooler Water Pump Speed |
According to the display on the GTS, read the Data List while the Active Test "Control the Intercooler Water Pump" is set to 85%.
| Result | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
Tech Tips
If the electric water pump assembly voltage is extremely high or low, control may be temporarily stopped and a DTC stored.
The coolant will freeze at -15°C (5°F) at 30% coolant concentration and at -35°C (-31°F) at 50% coolant concentration.
DTC P023A71 will be stored if the electric water pump assembly cannot rotate due to freezing of the coolant.
If DTC P023A71 is stored due to freezing of the coolant, the problem cannot be reproduced. Judge whether freezing of the coolant occurred from the coolant replacement history and the ambient temperature when the DTC was stored.
| B |
|
CHECK COOLANT LEVEL AT RESERVOIR Click here |
| C |
|
CHECK FOR INTERMITTENT PROBLEMS Click here |
| A |
|
REPLACE ELECTRIC WATER PUMP ASSEMBLY
Replace the electric water pump assembly.
| Result | ||
|---|---|---|
|
| NEXT |
|
GO TO STEP 8 Click here |
CHECK COOLANT LEVEL AT RESERVOIR
Check the coolant (for intercooler) level.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| B |
|
GO TO STEP 7 Click here |
| A |
|
CHECK FOR COOLANT LEAK
Check the turbocharger and intercooler cooling system for coolant leaks.
| OK |
|---|
| No leaks in turbocharger and intercooler cooling system. |
| Result | |||
|---|---|---|---|
|
| OK |
|
GO TO STEP 7 Click here |
| NG |
|
REPAIR COOLANT LEAK
Repair any coolant leaks.
| Result | ||
|---|---|---|
|
| NEXT |
|
BLEED AIR
Bleed the air and add coolant up to the FULL Line on the reservoir tank.
| Result | ||
|---|---|---|
|
| NEXT |
|
PERFORM ACTIVE TEST USING GTS (CONTROL THE INTERCOOLER WATER PUMP)
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Note
Be sure to perform the inspection with the battery voltage at 11 V or more.
Tech Tips
If the battery voltage is low, the electric water pump assembly may stop operating.
Enter the following menus: Powertrain / Engine / Active Test / Control the Intercooler Water Pump / Data List / Intercooler Water Pump Speed.
| Active Test Display |
|---|
| Control the Intercooler Water Pump |
| Data List Display |
|---|
| Intercooler Water Pump Speed |
According to the display on the GTS, read the Data List while the Active Test "Control the Intercooler Water Pump" is set to 85%.
| OK |
|---|
| The value of Intercooler Water Pump Speed is 4000 to 7000 rpm. |
| Result | ||
|---|---|---|
|
| NEXT |
|
END |