FRONT EVAPORATOR TEMPERATURE SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL NO. 1 COOLER THERMISTOR (w/o Stop And Start System)


    1. A01HFEUC01
      *1 Plastic Case
      *2 No. 1 Cooler Thermistor
      *a Range A
      *b 50.0 mm (1.9685 in.) (from tank upper surface)
      *c 56.1 mm (2.2087 in.) (from end face of No. 1 cooler evaporator sub-assembly)
      *d 42.7 mm (1.6811 in.) (from end face of No. 1 cooler evaporator sub-assembly)

      Install the No. 1 cooler thermistor as shown in the illustration.

      Note


      • Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

      • When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (A in the illustration).

      • After inserting the thermistor, do not apply excessive force to the wire.

      • Directly insert the thermistor until the edge of plastic case comes into contact with evaporator.

  2. INSTALL NO. 1 COOLER THERMISTOR (w/ Stop And Start System)


    1. A01HHY5C01
      *1 Plastic Case
      *2 No. 1 Cooler Thermistor
      *a Range A
      *b 50.0 mm (1.9685 in.) (from tank upper surface)
      *c 25.0 mm (0.9843 in.) (from tank upper surface)
      *d 54.4 mm (2.1417 in.) (from end face of No. 1 cooler evaporator sub-assembly)
      *e 41.0 mm (1.6142 in.) (from end face of No. 1 cooler evaporator sub-assembly)

      Install the No. 1 cooler thermistor as shown in the illustration.

      Note


      • Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

      • When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (A in the illustration).

      • After inserting the thermistor, do not apply excessive force to the wire.

      • Directly insert the thermistor until the edge of plastic case comes into contact with evaporator.

  3. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

    Click here

  4. INSTALL COOLER EXPANSION VALVE

    Click here

  5. INSTALL QUICK HEATER ASSEMBLY (for Cold Area)

    Click here

  6. INSTALL AIR CONDITIONING RADIATOR ASSEMBLY

    Click here