STARTER(w/o Stop And Start System) INSTALLATION

PROCEDURE

  1. INSTALL STARTER ASSEMBLY

    1. Install the starter assembly with the 2 bolts.

      37 N*m

      377 kgf*cm

      27 ft.*lbf

    2. Connect terminal 30 with the nut.

      9.8 N*m

      100 kgf*cm

      87 in.*lbf

    3. Install the terminal cap.

    4. Connect the starter assembly connector.

  2. INSTALL FLYWHEEL HOUSING SIDE COVER

    1. A316462C01

      *a

      Protrusion

      Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.

      Note:

      • Make sure the claw makes a click sound, indicating that it fits tightly.

      • Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.

  3. INSTALL NO. 1 ENGINE UNDER COVER

    Click hereClick here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here