POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Driver Door Window Only) Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch
| DTC Code | DTC Name |
|---|---|
| Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch |
DESCRIPTION
When the ignition switch is ON, the front door window regulator assembly (for passenger door) is operated by the power window regulator switch assembly.
WIRING DIAGRAM
for LHD
for RHD
CAUTION / NOTICE / HINT
Inspect the fuses for circuits related to this system before performing the following procedure.
Check that the window lock switch is off before performing the following procedure.
PROCEDURE
CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY - BATTERY)
Disconnect the G9*1 or H9*2 power window regulator switch assembly connector.
*1: for LHD
*2: for RHD
Measure the voltage according to the value(s) in the table below.
Standard Voltage
Table 1. for LHD Tester Connection
Condition
Specified Condition
G9-3 (B) - Body ground
Ignition switch ON
11 to 14 V
Table 2. for RHD Tester Connection
Condition
Specified Condition
H9-3 (B) - Body ground
Ignition switch ON
11 to 14 V
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
-
*a
Component without harness connected
(Power Window Regulator Switch Assembly)
Remove the power window regulator switch assembly.
Measure the resistance when the switch is operated according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
1 (D) - 2 (SD)
UP
Below 1 Ω
3 (B) - 4 (U)
Below 1 Ω
1 (D) - 2 (SD)
Off
Below 1 Ω
4 (U) - 5 (SU)
Below 1 Ω
4 (U) - 5 (SU)
DOWN
Below 1 Ω
1 (D) - 3 (B)
Below 1 Ω
Result
Proceed to
OK
NG
-
CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY - FRONT DOOR WINDOW REGULATOR ASSEMBLY (FOR PASSENGER DOOR))
Disconnect the G14*1 or H10*2 front door window regulator assembly (for passenger door) connector.
*1: for LHD
*2: for RHD
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Table 3. for LHD Tester Connection
Condition
Specified Condition
G9-4 (U) - G14-2 (U)
Always
Below 1 Ω
G9-1 (D) - G14-1 (D)
Always
Below 1 Ω
G9-4 (U) - Body ground
Always
10 kΩ or higher
G9-1 (D) - Body ground
Always
10 kΩ or higher
Table 4. for RHD Tester Connection
Condition
Specified Condition
H9-4 (U) - H10-2 (U)
Always
Below 1 Ω
H9-1 (D) - H10-1 (D)
Always
Below 1 Ω
H9-4 (U) - Body ground
Always
10 kΩ or higher
H9-1 (D) - Body ground
Always
10 kΩ or higher
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
Remove the power window regulator master switch assembly.
-
*a
Component without harness connected
(Power Window Regulator Master Switch Assembly (for LHD))
for LHD:
Measure the resistance when the switch is operated according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
15 (B) - 12 (U)
UP
Below 1 Ω
7 (E) - 16 (D)
Below 1 Ω
7 (E) - 12 (U)
Off
Below 1 Ω
7 (E) - 16 (D)
Below 1 Ω
15 (B) - 16 (D)
DOWN
Below 1 Ω
7 (E) - 12 (U)
Below 1 Ω
-
*a
Component without harness connected
(Power Window Regulator Master Switch Assembly (for RHD))
for RHD:
Measure the resistance when the switch is operated according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
15 (B) - 12 (U)
UP
Below 1 Ω
7 (E) - 10 (D)
Below 1 Ω
7 (E) - 12 (U)
Off
Below 1 Ω
7 (E) - 10 (D)
Below 1 Ω
15 (B) - 10 (D)
DOWN
Below 1 Ω
7 (E) - 12 (U)
Below 1 Ω
Result
Proceed to
OK
NG
CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY - POWER WINDOW REGULATOR SWITCH ASSEMBLY)
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Table 5. for LHD Tester Connection
Condition
Specified Condition
H11-12 (U) - G9-5 (SU)
Always
Below 1 Ω
H11-16 (D) - G9-2 (SD)
Always
Below 1 Ω
H11-12 (U) - Body ground
Always
10 kΩ or higher
H11-16 (D) - Body ground
Always
10 kΩ or higher
Table 6. for RHD Tester Connection
Condition
Specified Condition
G11-12 (U) - H9-5 (SU)
Always
Below 1 Ω
G11-10 (D) - H9-2 (SD)
Always
Below 1 Ω
G11-12 (U) - Body ground
Always
10 kΩ or higher
G11-10 (D) - Body ground
Always
10 kΩ or higher
Result
Proceed to
OK
NG
OK REPLACE FRONT DOOR WINDOW REGULATOR ASSEMBLY (FOR PASSENGER DOOR)
except Sedan:Click here
for Sedan:Click here
NG REPAIR OR REPLACE HARNESS OR CONNECTOR