REAR VIEW MONITOR SYSTEM

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tip:

  • Use these procedures to troubleshoot the rear view monitor system.

  • *: Using the GTS.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

    Result

    Proceed to

    NEXT
    NEXT

  2. INSPECT BATTERY VOLTAGE

    1. Measure the battery voltage with the ignition switch off.

    Standard voltage

    11 to 14 V

    If the voltage is below 11 V, replace or recharge the battery before proceeding.

    Result

    Proceed to

    NEXT
    NEXT

  3. CHECK DTC OF NAVIGATION SYSTEM OR AUDIO AND VISUAL SYSTEM

    1. w/ Navigation System: Refer to DTC Check/Clear procedures of the navigation system.

      Click here

    2. w/o Navigation System: Refer to DTC Check/Clear procedures of the audio and visual system.

      Click here

    Result

    Result

    Proceed to

    DTC is not output

    A

    DTC is output (w/ Navigation System)

    B

    DTC is output (w/o Navigation System)

    C
    B

    GO TO NAVIGATION SYSTEM

    Click here

    C

    GO TO AUDIO AND VISUAL SYSTEM

    Click here

    A

  4. CHECK FOR DTC*

    1. Check for DTCs and note any codes that are output.

      Click here

    2. Clear the DTC.

      Click here

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

    Result

    Result

    Proceed to

    DTC is not output

    A

    DTC is output

    B
    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART

    Click here

    A

  5. CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM OR AUDIO AND VISUAL SYSTEM

    1. w/ Navigation System: Refer to the navigation system.

      Click here

    2. w/o Navigation System: Refer to the audio and visual system.

      Click here

    Result

    Result

    Proceed to

    Symptom does not appear

    A

    Symptom appears

    B
    B

    FOLLOW THE NAVIGATION OR AUDIO AND VISUAL SYMPTOM CHART TO PERFORM TROUBLESHOOTING

    A

  6. PROBLEM SYMPTOMS TABLE

    1. Refer to the Problem Symptoms Table.

      Click here

    Result

    Result

    Proceed to

    Fault is not listed in problem symptoms table

    A

    Fault is listed in problem symptoms table

    B
    B

    ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

    A

  7. BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW

    1. Terminals of ECU.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  8. ADJUST, REPAIR OR REPLACE

    Result

    Proceed to

    NEXT
    NEXT

  9. CONFIRMATION TEST

    Result

    Proceed to

    NEXT
    NEXT

    END