SELECT STROKE SENSOR REMOVAL

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  2. REMOVE BATTERY

    Click hereClick hereClick here

  3. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click hereClick hereClick here

  4. REMOVE SELECT STROKE SENSOR

    1. C303292

      Disconnect the select stroke sensor connector.

    2. C303293

      Remove the 2 screws and select stroke sensor from the shift and select actuator assembly.

    3. Remove the O-ring from the select stroke sensor.