ECD SYSTEM (for DPF) Injector Circuit

DESCRIPTION

The injector driver drives the injectors at high speeds with a high-voltage DC/DC converter. The ECM constantly monitors the injector driver and stops the engine if an abnormal condition is detected.

WIRING DIAGRAM

Refer to DTC P0201 Click here.

INSPECTION PROCEDURE

Note


  • Inspect the fuses of circuits related to this system before performing the following inspection procedure.

  • After replacing the ECM, the new ECM needs registration Click here and initialization Click here.

  • After replacing the fuel supply pump assembly, the ECM needs initialization Click here.

  • After replacing an injector assembly, the ECM needs registration Click here.

PROCEDURE


  1. CHECK INJECTOR DRIVER (POWER SOURCE)


    1. A01DYSSE15
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Injector Driver)

      Disconnect the injector driver connectors.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      I20-2 (+B) - I20-4 (GND) Ignition switch ON 11 to 14 V

    3. Reconnect the injector driver connectors.


    NG

    INSPECT NO. 1 INTEGRATION RELAY (EDU RELAY) Click here

    OK

    REPLACE INJECTOR DRIVER Click here

  2. INSPECT NO. 1 INTEGRATION RELAY (EDU RELAY)


    1. Inspect the No. 1 integration relay (EDU relay) Click here.


    NG

    REPLACE NO. 1 INTEGRATION RELAY (EDU RELAY)

    OK

  3. CHECK HARNESS AND CONNECTOR (INJECTOR DRIVER - NO. 1 INTEGRATION RELAY)


    1. Remove the No. 1 integration relay from the engine room relay block and junction block assembly.

    2. Disconnect the injector driver connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I20-2 (+B) - 1J-8 Always Below 1 Ω
      I20-4 (GND) - Body ground Always Below 1 Ω
      I20-2 (+B) or 1J-8 - Body ground Always 10 kΩ or higher

    4. Reconnect the injector driver connector.

      Reinstall the No. 1 integration relay.


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. CHECK HARNESS AND CONNECTOR (ECM - NO. 1 INTEGRATION RELAY)


    1. Remove the No. 1 integration relay from the engine room relay block and junction block assembly.

    2. Disconnect the ECM connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E30-12 (IREL) - 1J-7 Always Below 1 Ω
      E30-12 (IREL) or 1J-7 - Body ground Always 10 kΩ or higher

    4. Reconnect the ECM connector.

    5. Reinstall the No. 1 integration relay.


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE ECM Click here