FRONT SEAT OUTER BELT ASSEMBLY(for 3 Door) INSTALLATION
CAUTION / NOTICE / HINT
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
INSPECT FRONT SEAT OUTER BELT ASSEMBLY
INSTALL FRONT SEAT OUTER BELT ASSEMBLY
-
Temporarily install the front seat outer belt assembly with the 2 bolts.
Fully tighten the bolt <A> first, then the bolt <B> to install the front seat outer belt assembly.
Bolt <A>
4.9 N*m
50 kgf*cm
43 in.*lbf
Bolt <B>
42 N*m
428 kgf*cm
31 ft.*lbf
-
*a
Locking Button
*b
Lock
Connect the pretensioner connector and lock the locking button as shown in the illustration.
Note:Securely lock the locking button.
Connect the shoulder anchor of the front seat outer belt assembly with the bolt.
42 N*m
428 kgf*cm
31 ft.*lbf
Check that the ELR locks.
Note:This check should be performed with the front seat outer belt assembly installed.
With the front seat outer belt assembly installed, check that the belt locks when it is pulled out quickly.
-
INSTALL INNER ROOF SIDE GARNISH
INSTALL ROOF SIDE GARNISH END COVER
INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY
INSTALL INNER ROOF SIDE GARNISH COVER (w/o Luggage Compartment Room Light)
INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (w/ Luggage Compartment Room Light)
CONNECT NO. 1 REAR SEAT OUTER BELT ASSEMBLY
CONNECT FRONT SEAT OUTER BELT ASSEMBLY
Connect the floor anchor of the front seat outer belt assembly with the bolt.
42 N*m
428 kgf*cm
31 ft.*lbf
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
for LH Side:Click hereClick here
for RH Side:Click hereClick here
INSTALL COWL SIDE TRIM SUB-ASSEMBLY
INSTALL REAR SEAT ASSEMBLY (for Bench Seat Type)
INSTALL REAR SEAT ASSEMBLY (for Separate Seat Type)
INSTALL REAR FLOOR MAT ASSEMBLY
INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
INSPECT SRS WARNING LIGHT