DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:C1A10

DTC Code DTC Name
C1A10 Front Radar Sensor

DESCRIPTION

The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect obstacles in front of the vehicle.

Based on this information, the driving support ECU assembly sends dynamic radar cruise control operation signals.

When the driving support ECU assembly receives information that there is a malfunction in the millimeter wave radar sensor assembly, DTC C1A10 is stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1A10

Front Radar Sensor

While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the driving support ECU assembly receives a malfunction signal from the millimeter wave radar sensor assembly for approximately 0.3 seconds or more.

  • Millimeter wave radar sensor assembly

  • Driving support ECU assembly

CAUTION / NOTICE / HINT

Note:

  • When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

  • When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

    Click here

  • First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.

    for LHD with Central Gateway ECU:Click here

    for RHD with Central Gateway ECU:Click here

PROCEDURE

  1. REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

    1. Replace the millimeter wave radar sensor assembly with a new one.

      Click here

    2. Perform millimeter wave radar sensor assembly adjustment.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  2. CHECK FOR DTCs

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Clear the DTCs.

      Click here

      Powertrain > Radar Cruise2 > Clear DTCs

    4. Make sure that the DTC detection conditions are met.

      Tip:

      If the detection conditions are not met, the system cannot detect the malfunction.

      Tip:

      If the detection conditions are not met, the system cannot detect the malfunction.

      1. Turn the ignition switch to ON.

      2. Turn the dynamic radar cruise control system on using the cruise control switch (ON/OFF).

      3. Drive the vehicle at 36 km/h (22 mph) or more for 0.3 seconds or more.

    5. Enter the following menus: Powertrain / Radar Cruise2 / Trouble Codes.

    6. Check for DTCs.

      Click here

      Powertrain > Radar Cruise2 > Trouble Codes

      Result

      Result

      Proceed to

      DTC C1A10 is not output

      A

      DTC C1A10 is output

      B
    A

    END (MILLIMETER WAVE RADAR SENSOR ASSEMBLY WAS DEFECTIVE)

    B

    REPLACE DRIVING SUPPORT ECU ASSEMBLY

    for LHD:Click here

    for RHD:Click here