FRONT SEAT ASSEMBLY(for Power Seat) REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:


    • Be sure to read Precaution thoroughly before servicing Click here.

    • Wear protective gloves. Sharp areas on the parts may injure your hands.

    • If the front seat side airbag assembly has deployed, replace the front seat side airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

    Note


    • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE DECK BOARD ASSEMBLY

    Click here

  3. REMOVE NO. 1 DECK BOARD

    Click here

  4. REMOVE NO. 2 DECK BOARD

    Click here

  5. REMOVE REAR DECK FLOOR BOX

    Click here

  6. REMOVE DECK FLOOR BOX RH

    Click here

  7. REMOVE FRONT SEAT HEADREST ASSEMBLY

  8. REMOVE FRONT INNER SEAT TRACK BRACKET COVER


    1. Operate the slide and vertical power seat switch knob and move the front seat assembly to the rearmost position.

    2. A005E4R

      Disengage the 2 claws to remove the front inner seat track bracket cover.

  9. REMOVE FRONT OUTER SEAT TRACK BRACKET COVER


    1. A005A79

      Disengage the 2 claws to remove the front outer seat track bracket cover.

  10. REMOVE REAR INNER SEAT TRACK BRACKET COVER


    1. Operate the slide and vertical power seat switch knob and move the front seat assembly to the foremost position.

    2. A005CCA

      Disengage the claw.

    3. Disengage the guide to remove the rear inner seat track bracket cover.

  11. REMOVE REAR OUTER SEAT TRACK BRACKET COVER


    1. A005EV9

      Disengage the 2 claws to remove the rear outer seat track bracket cover.

  12. REMOVE FRONT SEAT ASSEMBLY


    1. A005AHN

      Remove the 2 bolts on the rear side of the front seat assembly.

    2. Operate the slide and vertical power seat switch knob and move the front seat assembly to the rearmost position.

    3. A005CY0

      Remove the 2 bolts on the front side of the front seat assembly.

    4. Operate the reclining power seat switch knob and move the seatback to the upright position.

    5. Operate the slide and vertical power seat switch knob and move the front seat assembly to the center position.

    6. Disconnect the cable from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative auxiliary (-) battery terminal to disable the SRS system.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    7. Disconnect each connector under the front seat assembly.

    8. Remove the front seat assembly.

      Note

      Be careful not to damage the vehicle body.