TRANSMITTER BATTERY(w/ Entry and Start System) REPLACEMENT

PROCEDURE

  1. REMOVE TRANSMITTER BATTERY

    Note:

    Take extra care when handling these precision electronic components.

    1. B370095

      Push the release hook knob and remove the mechanical key.

    2. B370097C01

      *a

      Protective Tape

      Insert a precision screwdriver into the gap, and turn the screwdriver to remove the transmitter housing cover.

      Tip:

      Tape the screwdriver tip before use.

    3. B370098

      Remove the transmitter battery housing cover as shown in the illustration.

    4. B370100C01

      *a

      Protective Tape

      Insert a precision screwdriver into the gap and gently remove the transmitter battery.

      Note:

      • Do not push the terminals with your finger.

      • Do not forcibly pry up the transmitter battery as the terminals may be damaged.

      • Do not touch the transmitter battery with wet hands. Moisture may cause rust.

      • Do not touch or move any components inside the transmitter. It may interfere with proper operation.

      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.

      Tip:

      Tape the screwdriver tip before use.

  2. INSTALL TRANSMITTER BATTERY

    1. B370101

      Install a new transmitter battery with the positive (+) side facing upward, as shown in the illustration.

      Note:

      • Do not bend the transmitter battery electrode during insertion.

      • Keep the inside of the transmitter housing cover free of dust and oil.

      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.

    2. B370099

      Install the transmitter battery housing cover as shown in the illustration.

    3. B370102

      Install the transmitter housing cover by pressing down on it as shown in the illustration.

    4. B370096

      Insert the mechanical key into the transmitter.

    5. Press one of the transmitter switches and check that the LED illuminates.

      OK

      Transmitter LED illuminates when a switch is pressed.