LIGHTING SYSTEM CUSTOMIZE PARAMETERS

  1. CUSTOMIZE LIGHTING SYSTEM

    1. Customizing with the GTS

      1. Connect the GTS to the DLC3.

      2. Turn the ignition switch to ON.

      3. Turn the GTS on.

      4. Enter the following menus: Customize Setting / Warning.

      5. Select the setting by referring to the table below.

        Note:

        Record the current settings before customizing.

        Warning

        Tester Display

        Description

        Default

        Setting

        ECU

        Lane Change Flashing Times Setting

        Function to change the lane change flashing times

        3

        00:OFF,01:3,10:5,11:7

        Combination meter assembly

    2. Customizing Automatic Light Control System Sensitivity

      1. Set the sensitivity of the automatic light control system by performing the following procedure. The sensitivity of the automatic light control system and corresponding number of times to operate the light control switch (number of times headlights flash) are as follows.

        Standard

        Automatic Light Control System Sensitivity

        Number of Light Control Switch Operations

        -40%

        1

        -20%

        2

        0%

        3

        +20%

        4

        +40%

        5
        Tip:

        The default setting of the automatic light control system sensitivity is 0% (number of light control switch operations: 3).

        Step

        Operation

        Remark

        1

        1. Turn the ignition switch to ON.

        2. Check that the dimmer switch is in the neutral position.

        3. Turn the light control switch to the TAIL position.

        -

        2

        1. Turn the ignition switch off.

        2. Hold the dimmer switch to the high flash position.

        3. Turn the light control switch to the HEAD position.(*1)

        4. Turn the light control switch to the TAIL position.(*2)

        5. Repeat steps *1 and *2 5 times.

        6. Move the dimmer switch to the neutral position.

        • Step 2 lists operations for changing to automatic light control system sensitivity customize setting mode.

        • If operations other than those described in step 2 are performed, the mode will change to normal mode. Perform the procedure from step 1 again.

        • Make sure to finish step 2 within 40 seconds.

        3

        1. Check that the mode has changed to the automatic light control system sensitivity customize setting mode.

          OK

          The headlights flash a number of times which corresponds to the number of times the light control switch was operated to select the current automatic light control system sensitivity setting.

        -

        4

        1. Hold the dimmer switch to the high flash position.

        2. Turn the light control switch to the HEAD position.(*3)

        3. Turn the light control switch to the TAIL position.(*4)

        4. Repeat steps *3 and *4 for the number of light control switch operations corresponding to the desired automatic light control system sensitivity setting.

        5. Move the dimmer switch to the neutral position.

        • If operations other than those described in step 4 are performed, the mode will change to normal mode. Perform the procedure from step 1 again.

        • Make sure to finish step 4 within 40 seconds.

        5

        1. Check the answer back for the completion of setting the automatic light control system sensitivity.

          OK

          The headlights flash a number of times which corresponds to the number of times the light control switch was operated to select the desired automatic control system sensitivity setting.

        -

        6

        1. Setting is complete.

        -