VEHICLE STABILITY CONTROL SYSTEM Slip Indicator Light does not Come ON

DTC Code DTC Name
Slip Indicator Light does not Come ON

DESCRIPTION

Refer to Slip Indicator Light Remains ON (Click here).

WIRING DIAGRAM

Refer to Slip Indicator Light Remains ON (Click here).

CAUTION / NOTICE / HINT

Note:

When replacing the master cylinder solenoid, perform calibration (Click here).

PROCEDURE

  1. READ VALUE USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT)

    1. Turn the engine switch off.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the engine switch on (IG).

    4. Turn the intelligent tester on.

    5. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

      Chassis > ABS/VSC/TRC > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      Slip Indicator Light

      Slip indicator light

      ON or OFF

      ON: Indicator light on

      OFF: Indicator light off

      -

    6. When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List.

      Click here

      Chassis > ABS/VSC/TRC > Active Test

      Tester Display

      Measurement Item

      Control Range

      Diagnostic Note

      Slip Indicator Light

      Slip indicator light

      Indicator light ON/OFF

      Observe the combination meter.

      Result

      Result

      Proceed to

      Data List Display

      Data List Display when Performing Active Test ON/OFF Operation

      ON

      Changes between ON and OFF

      A

      Does not change between ON and OFF

      B

      OFF

      Changes between ON and OFF

      A

      Does not change between ON and OFF

      B
    A

    GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

    Click here

    B

    REPLACE MASTER CYLINDER SOLENOID

    Click here