FUEL SENDER GAUGE ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL FUEL SENDER GAUGE ASSEMBLY


    1. B006CB8

      Set the fuel sender gauge assembly on the No. 1 fuel sub-tank. Then slide the fuel sender gauge assembly downward to install it.

    2. Connect the fuel sender gauge assembly connector.

  2. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

    Click here

  3. INSTALL FUEL TANK VENT TUBE SET PLATE

    Click here

  4. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

    Click here

  5. INSTALL NO. 2 REAR FLOOR SERVICE HOLE COVER

    Click here

  6. INSTALL NO. 2 FUEL SENDER GAUGE ASSEMBLY


    1. Install the No. 2 fuel sender gauge assembly to the fuel tank assembly with the 5 screws.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }

  7. INSTALL NO. 1 REAR FLOOR SERVICE HOLE COVER


    1. Connect the No. 2 fuel sender gauge assembly connector.

    2. Install the No. 1 rear floor service hole cover with new butyl tape.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  9. INSPECT FOR FUEL LEAK

    Click here

  10. INSTALL REAR SEAT CUSHION ASSEMBLY