WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS REPAIR PROCEDURE OF HEADLIGHT ASSEMBLY

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • If the installation area of the headlight assembly is damaged, use a supply retainer for a low-cost repair.

  • Ensure that the headlight assembly is not damaged.

  1. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER

    1. E351129

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Tip:

      After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E351130

      Install the upper headlight protector retainer with the screw.

  2. INSTALL UPPER NO. 2 HEADLIGHT PROTECTOR RETAINER

    1. E351131

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Tip:

      After cutting off the part, place the upper No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E351132

      Install the upper No. 2 headlight protector retainer with the 2 screws.

  3. INSTALL UPPER NO. 3 HEADLIGHT PROTECTOR RETAINER

    1. E351133

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Tip:

      After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E351134

      Install the upper No. 3 headlight protector retainer with the 2 screws.