UNDER BODY REFERENCE VALUES THREE-DIMENSIONAL DISTANCE

Tech Tips


  • Measure points with the engine under cover No.1 removed.

  • In cases in which only one dimension is given, left and right are symmetrical.

  • For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).

Measuring Point Name
Symbol Name

Hole Diameter

mm (in.)
A, a Front Cross Member Lower Standard Hole φ13 (0.51)
B, b Front Side Member Standard Hole φ18 (0.71)
C, c Front Suspension Crossmember Installation Bolt M14 (0.55)
D, d Front Suspension Crossmember Installation Bolt M16 (0.63)
E, e Front Side Member Reinforcement No.5 Standard Hole φ25 (0.98)
A01O6VLC01
*a Distance between points other than those above *b

mm

(in.)