REAR DOOR BELT MOULDING INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. INSTALL REAR DOOR OUTER GLASS WEATHERSTRIP LH


    1. Attach the 4 claws to install the rear door outer glass weatherstrip.

  2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. Attach the 9 clips to install the rear door trim board.

    2. Install the screw and clip.

  3. INSTALL DOOR PULL HANDLE


    1. Install the door pull handle with the screw.

  4. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)


    1. Connect the connector.

    2. Attach the 2 claws and 2 clips to install the rear power window regulator switch assembly with rear door armrest base panel.

  5. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    1. Temporarily install the rear door window regulator handle, fully close the window, and then remove the rear door window regulator handle.

    2. Install the plate and snap ring to the rear door window regulator handle.

    3. A01DY7PE01
      Text in Illustration
      *1 Snap Ring
      *2 Plate
      *a Front Side

      Install the rear door window regulator handle to the rear door window regulator as shown in the illustration.

      Standard
      Area Specified Condition
      A 18 to 42°