STEERING WHEEL REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during steering wheel assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

Panoramic View Monitor System

Click here

Note


  • Do not remove/install the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the ignition switch ON.

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  2. REMOVE HORN BUTTON ASSEMBLY

    Click here

  3. REMOVE STEERING WHEEL ASSEMBLY


    1. Disconnect each connector from the spiral cable with sensor sub-assembly.

    2. w/ Steering Heater:


      1. B0087OP

        Disconnect the steering heater connector.

    3. B00895U

      Using a 10 mm hexagon socket wrench, remove the steering wheel assembly set bolt.

    4. B0083H5C01
      *a Matchmark

      Put matchmarks on the steering wheel assembly and steering main shaft.

    5. Temporarily install the steering wheel assembly set bolt.

      Note

      Do not overtighten the steering wheel assembly set bolt.

    6. B0086G2C01
      *a Turn
      *b Hold

      Using SST, separate the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05031, 09957-04010 )
      09950-60010   ( 09951-00330 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

    7. Remove the steering wheel assembly set bolt and steering wheel assembly.

  4. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  5. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)

    Click here

  6. REMOVE NO. 1 SWITCH WIRE (w/ Shift Paddle Switch)

    Click here