CAMSHAFT OIL CONTROL VALVE(for Intake Side) INSTALLATION

PROCEDURE


  1. SET NO. 1 CYLINDER TO TDC/COMPRESSION

    Click here

  2. INSTALL CAMSHAFT TIMING GEAR BOLT

    Note

    There are different types of camshaft timing gear bolts. Make sure to check the identification mark to determine the tightening torque.

    Identification Mark:
    Item Identification Mark
    for Type A A
    for Type B C
    B008GJJC02
    *a Identification Mark

    1. B008HWW

      Apply engine oil to the areas of the camshaft timing gear bolt shown in the illustration.

    2. Temporarily install the camshaft timing gear bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Tech Tips

      Make sure that the flange part of the camshaft timing gear bolt is directly contacting the camshaft timing gear assembly.

    3. Loosen the camshaft timing gear bolt 60 to 180°.

    4. Turn the crankshaft pulley assembly clockwise approximately 60 to 120°.

    5. B008HKCN01

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015
      09330-00021

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    6. Tighten the camshaft timing gear bolt.

      Torque:
      Type A
      120 N*m  { 1224 kgf*cm, 89 ft.*lbf }
      Type B
      95 N*m  { 969 kgf*cm, 70 ft.*lbf }

  3. INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY

    Click here

  4. INSPECT FOR OIL LEAK

    Click here