REAR DOOR SPEAKER INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. INSTALL REAR SPEAKER ASSEMBLY

    Note:

    Do not touch the cone part of the speaker.

    1. Install a nose piece to an air riveter or hand riveter. Then insert the mandrel part of a new φ4 mm waterproof rivet into the nose piece.

    2. B335799

      Using an air riveter or hand riveter, install the rear speaker assembly with 3 new rivets.

      Note:
      • B171664C05

        *1

        Mandrel

        *2

        Riveter

        *a

        INCORRECT

        *b

        CORRECT

        Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

      • B172390C05

        *1

        Riveter

        *a

        INCORRECT

        *b

        CORRECT

        Confirm that the rivets are seated properly against the speaker.

      • Do not tilt the riveter when installing the rivet to the speaker.

      • Do not leave any space between the rivet head and speaker.

      • B172391C04

        *1

        Riveter

        *a

        INCORRECT

        *b

        CORRECT

        Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.

    3. Connect the connector.

  2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  3. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  4. INSTALL DOOR ASSIST GRIP COVER LH

    Click here

  5. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here